Highway & Freeway Driving — Minnesota

Minnesota CDL practice test: 458 free practice questions (Based on the official driver handbook). The official format is not yet verified; check the official site before your test. Highway & Freeway Driving: 4 questions. Updated

Entering and exiting freeways, lane changes, overtaking and HOV lane rules.

This topic page is still being reviewed against the official handbook. Until review is finished it is hidden from search engines.

Topic / MetricValue
TopicHighway & Freeway Driving
License testMinnesota CDL permit (CLP) knowledge tests
Topic questions4 (1% of 458 total)
Review statusThis topic page is still being reviewed against the official handbook. Until review is finished it is hidden from search engines.

Official handbook

Not yet verified State CDL manual (based on the AAMVA model manual) link not yet collected

Advertisement

Questions (4)

1. When driving at highway speeds, you should watch the road about ____ ahead of your vehicle.
  1. One block
  2. 100 yards
  3. A quarter mile ✓

Answer: C. A quarter mile

At highway speeds you should watch the road about a quarter mile ahead of your vehicle. The handbook explains that good drivers look 12 to 15 seconds ahead, which is the distance the vehicle will cover in that time. At lower speeds that works out to roughly one block, and at highway speeds it comes to about a quarter mile. Looking that far ahead matters because stopping and lane changes take a lot of distance, so you need to see traffic early enough to have room to make those moves safely. Close attention still counts; good drivers shift their eyes between near and far.
2. When changing lanes, turn signals:
  1. Should not be used.
  2. Should only be used if a vehicle is close to you.
  3. Should be used each time. ✓

Answer: C. Should be used each time.

Turn signals should be used each time you change lanes. The handbook's lane-change instructions start with putting your turn signal on before you change lanes, and it tells you to check your mirrors again after you have signaled to confirm nobody slipped into your blind spot. The on-road section repeats that you activate turn signals when required and cancel them once the lane change is finished. Nothing in these passages makes signaling depend on whether another vehicle happens to be near you, so the signal is simply part of every lane change.
3. When changing lanes:
  1. You should not use your mirrors.
  2. You should use your mirrors. ✓
  3. You should not use your turn signals.

Answer: B. You should use your mirrors.

When you change lanes, you should use your mirrors. The handbook treats lane changes as a special situation that calls for more than a quick glance. It says you need mirror checks to see whether someone is beside you or coming up to pass, and it lists checks before the move, after signaling, right after starting, and after finishing. It also describes using proper signals when changing lanes during the road test. Together, those points make mirror use part of a safe lane change, not something to skip.
4. When passing another vehicle, you should:
  1. Make eye contact with the driver.
  2. Assume the other driver doesn't see you. ✓
  3. Honk your horn.
  4. Not use a turn signal.

Answer: B. Assume the other driver doesn't see you.

When passing another vehicle, assume the other driver does not see you. The handbook says other drivers may not notice your vehicle even when it is clearly visible. When you are about to pass a vehicle, pedestrian, or bicyclist, it tells you to assume they do not see you, because they could move in front of you. It also says to drive carefully enough to avoid a crash even if they do not see or hear you. A light horn tap when legal, or flashing lights at night, is extra communication; it does not replace that assumption.
Advertisement

Source

Last checked: 2026-10-17 · Verified from official source

Updated: · Based on the official driver handbook