Speed Limits & Following Distance — Hawaii
Hawaii CDL practice test: 378 free practice questions (Based on the official driver handbook). The official format is not yet verified; check the official site before your test. Speed Limits & Following Distance: 17 questions.
Posted speed limits, school and construction zones, stopping and following distance.
This topic page is still being reviewed against the official handbook. Until review is finished it is hidden from search engines.
| Topic / Metric | Value |
|---|---|
| Topic | Speed Limits & Following Distance |
| License test | Hawaii CDL permit (CLP) knowledge tests |
| Topic questions | 17 (4% of 378 total) |
| Review status | This topic page is still being reviewed against the official handbook. Until review is finished it is hidden from search engines. |
Official handbook
Not yet verified
Advertisement
Questions (17)
1. A highway curve should be taken:
- At or slightly above the posted speed limit.
- At the posted speed limit.
- Well below the posted speed limit. ✓
Answer: C. Well below the posted speed limit.
A highway curve should be taken well below the posted speed limit. The tank vehicle section warns that liquid tankers are top-heavy and easy to roll over, and that tests have shown tankers can turn over at the posted speed for a curve. It directly says to take highway curves and ramp curves well below the posted speeds. The driving safely section adds that a high-center-of-gravity truck can roll over at the posted curve speed, so you should slow to a safe speed before entering the curve.
2. While operating on a downgrade, you should brake until you reach a speed that is:
- 5 mph below your safe speed. ✓
- 10 mph below your safe speed.
- 15 mph below your safe speed.
Answer: A. 5 mph below your safe speed.
Brake until you are about 5 mph below your safe speed, then release the brakes. The handbook describes the braking technique for a long or steep downgrade. With the vehicle in the proper low gear, the engine does most of the slowing and the brakes are only a supplement. You apply the brakes enough to cause a clear slowdown, then release them once your speed is roughly five mph under your safe speed. When speed rises back to the safe speed, you repeat the process. That makes five mph below safe speed the release point.
3. The weight of a truck:
- Usually has no impact on stopping distance.
- Is a major factor affecting stopping distance. ✓
- Is not as important as the type of cargo in determining stopping distance.
Answer: B. Is a major factor affecting stopping distance.
The weight of a truck is a major factor affecting stopping distance. The handbook's section on speed and stopping distance includes a discussion of how vehicle weight affects stopping distance. It says the heavier the vehicle, the more work the brakes have to do to stop it, and the more heat they absorb. That means a loaded or heavy truck takes more braking effort than a light one, so weight is a big factor in how long it takes to stop, not a minor detail you can ignore when judging your following distance and speed.
4. If being tailgated, you should:
- Increase your speed.
- Increase the amount of space between your vehicle and the vehicle in front of you. ✓
- Make quick movements.
Answer: B. Increase the amount of space between your vehicle and the vehicle in front of you.
You should increase the amount of space between your vehicle and the vehicle in front of you. The handbook says that when someone is tailgating you, opening up room ahead helps you avoid sudden speed or direction changes. It also gives the tailgater an easier chance to get around you. The same passage says not to speed up and to avoid quick changes, so the safe response is to create more following distance in front rather than reacting sharply or going faster.
5. An Individual Vehicle Distance Record (IVDR) does not need to include which of the following?
- The dates of a trip
- The total distance traveled
- The number of vehicles passed ✓
Answer: C. The number of vehicles passed
An Individual Vehicle Distance Record does not need to include the number of vehicles passed. The handbook describes the IVDR as a trip record that shows the distance traveled and the fuel purchased for a vehicle running interstate under apportioned registration and IFTA credentials. It also says that although the layout of the form can differ, the information required for proper record keeping stays the same, and the licensee must keep records that back up the quarterly tax return. Counting the vehicles you pass has nothing to do with miles driven or fuel burned, so it falls outside what the record is meant to capture.
6. If you are braking on dry pavement while traveling at 55 mph, how much distance will brake lag add to your overall stopping distance?
- 32 feet ✓
- 45 feet
- 20 feet
Answer: A. 32 feet
Brake lag adds 32 feet to your overall stopping distance. The handbook explains that with air brakes there is a delay while air flows through the lines before the brakes actually work. At 55 mph on dry pavement, that brake lag distance is about 32 feet. The handbook also lists brake lag as one of the four parts of total stopping distance, along with perception, reaction, and braking distance. So the added distance from brake lag is 32 feet.
7. If you are being tailgated while driving a large vehicle, do all of the following, except:
- Reduce your speed gradually.
- Increase your following distance.
- Increase your speed. ✓
Answer: C. Increase your speed.
Increase your speed is the one thing you should not do when a vehicle is tailgating you. The handbook's advice for a tailgater starts with avoiding quick changes: signal early and bring your speed down gradually rather than suddenly. It also says to open up the room in front of you, because that extra space means you won't have to make abrupt speed or direction changes and it gives the tailgater an easier chance to pass. On speeding up, the handbook is direct: don't. Being followed closely is safer at a low speed than at a high speed. So the item that does not belong on the list is increasing your speed.
8. When in heavy traffic, the safest driving speed is:
- Slower than the speed being driven by surrounding traffic.
- The same speed being driven by surrounding traffic. ✓
- Faster than the speed being driven by surrounding traffic.
Answer: B. The same speed being driven by surrounding traffic.
In heavy traffic, the safest speed is the same speed the surrounding traffic is driving. The handbook says directly that when traffic is heavy you should travel at the speed of other vehicles, because vehicles moving the same direction at the same speed are not likely to run into one another. It adds that you should drive with the flow of traffic if you can do so without going at an illegal or unsafe speed. That is why matching surrounding traffic is the correct choice, not picking a speed above or below the pack.
9. You should maintain at least ____ of following distance per every 10 feet of your vehicle when you are traveling more slowly than 40 mph.
- One second ✓
- Two seconds
- Three seconds
Answer: A. One second
You should keep at least one second of following distance for every 10 feet of your vehicle when traveling below 40 mph. The handbook gives a simple space-ahead rule: below 40 mph, allow at least one second for each 10 feet of vehicle length. It illustrates this with a 40-foot vehicle needing 4 seconds and a 60-foot vehicle needing 6 seconds. When speed goes above 40 mph, the handbook says to add one more second. The bank answer matches that rule for speeds under 40 mph.
10. When driving a 50-foot truck at 50 mph, your minimum following distance should be:
- Four seconds.
- Five seconds.
- Six seconds. ✓
Answer: C. Six seconds.
At 50 mph in a 50-foot truck, allow at least six seconds of following distance. The handbook's following-distance rule starts with one second for every ten feet of vehicle length, so a 50-foot truck gets a five-second base. It then says to add one second when your speed is above 40 mph. At 50 mph, that extra second brings the minimum to six seconds. The same passage shows the pattern with a 40-foot truck: four seconds normally, or five seconds over 40 mph.
Advertisement
Source
Last checked: 2026-10-17 · Verified from official source
Updated: · Based on the official driver handbook