Licensing, Demerits & Penalties — Alaska

Alaska CDL practice test: 416 free practice questions (Based on the official driver handbook). The official format is not yet verified; check the official site before your test. Licensing, Demerits & Penalties: 5 questions. Updated

Graduated licensing conditions, demerit points, suspensions, insurance and fines.

This topic page is still being reviewed against the official handbook. Until review is finished it is hidden from search engines.

Topic / MetricValue
TopicLicensing, Demerits & Penalties
License testAlaska CDL permit (CLP) knowledge tests
Topic questions5 (1% of 416 total)
Review statusThis topic page is still being reviewed against the official handbook. Until review is finished it is hidden from search engines.

Official handbook

Not yet verified State CDL manual (based on the AAMVA model manual) link not yet collected

Advertisement

Questions (5)

1. When taking the driving test and asked to make a turn, you should:
  1. Not use a turn signal since you were told to make the turn.
  2. Check traffic only to your right.
  3. Check traffic in all directions. ✓

Answer: C. Check traffic in all directions.

When the examiner asks you to make a turn, check traffic in all directions. The handbook's intersection instructions say that when you have been asked to make a turn, you check traffic in all directions, and it repeats that instruction as you approach the intersection. The same section also tells you to use your turn signals and to get into the lane the turn needs, so the turn is not a moment to relax just because someone told you where to go.
2. In an empty combination vehicle, the stiff suspension springs and strong brakes will have:
  1. High traction.
  2. Low traction. ✓
  3. No traction.

Answer: B. Low traction.

In an empty combination vehicle, the stiff suspension springs and strong brakes give low traction. The handbook says that when a combination vehicle is lightly loaded, its very stiff suspension springs and strong brakes produce poor traction. An empty vehicle is lightly loaded, so the same condition applies. The handbook adds that this poor traction makes it easy to lock up the wheels, and it warns that the trailer can swing out or the tractor can jackknife quickly. That is why you control speed and brake early whether loaded or empty.
3. During the driving test, the examiner will be scoring you on:
  1. How well-spoken you are.
  2. How quickly you arrive to your destination.
  3. General driving behavior. ✓

Answer: C. General driving behavior.

The examiner will be scoring your general driving behavior, along with specific driving maneuvers. The handbook says that during the road test the examiner scores both particular maneuvers and your general driving behavior. It also explains that you follow the examiner's directions, get enough time to respond, and are never asked to drive unsafely. That points to a broad judgment of how you drive overall, which is what the correct choice describes. Speaking ability and arrival speed are not what the scoring is about.
4. When asked to make a lane change during the driving test, you should:
  1. Make the change as soon as the examiner asks, without looking.
  2. Use your turn signal and change lanes when safe. ✓
  3. Make the lane change as quickly as possible, even if that means cutting off another driver.

Answer: B. Use your turn signal and change lanes when safe.

You should use your turn signal and change lanes when it is safe, after making the necessary traffic checks. The handbook's on-road driving section says that during lane-change portions of the test you will be asked to move left and then back right. It tells you to make the necessary traffic checks first, then use proper signals and change lanes smoothly when it is safe. The driving-safely section adds that lane changes are a special situation and that you check mirrors before changing lanes to make sure there is room. That supports signaling and waiting for a safe gap rather than moving immediately or rushing.
5. When taking a driving test:
  1. You must supply the same type of vehicle for which you will require a CDL. ✓
  2. You may supply any type of vehicle, even if it is not the type of vehicle for which you will be using with the CDL.
  3. The testing station will supply the vehicle.

Answer: A. You must supply the same type of vehicle for which you will require a CDL.

You must supply the same type of vehicle for which you will require a CDL. The handbook says the CDL skills test includes a vehicle inspection, basic control, and on-road driving, and that you must take these tests in the type of vehicle for which you wish to be licensed. It also says you will inspect your vehicle. So the vehicle you bring to the test has to match the CDL class you are applying for.
Advertisement

Source

Last checked: 2026-10-17 · Verified from official source

Updated: · Based on the official driver handbook